opensource.net.my

Shortcut for Transfer and upgrade firmware for H3C-S3600EI

tftp 192.168.1.100 get S3600EI-CMW310-R1602P10.bin

tftp 192.168.1.100 get H3C-http3.1.8-0040.web

tftp 192.168.1.100 get S3600_V514.btm

boot boot-loader unit1>flash:/S3600EI-CMW310-R1602P10.bin

boot bootrom unit1>flash:/S3600_V514.btm

boot web-package h3c-http3.1.8-0040.web main

Steps to configure S3600EI

1- Login to switch console and set the ip address and subnet mask for the switch. Type save to save the command.
2- TFTP from switch and connect to TFTP to transfer the firmware, bootrom and web file (refer above shortcut)
3- After transfer, follow above command to boot the file from the system (boot-loader and bootrom only). Then reboot the system
4- Type (display version and display boot-loader) to view the booted boot-loader and bootrom file
5- After type above command, follow above shortcut for boot web-package to boot web file. Reboot the system after typed.
6- Type (display web package) to view the booted web file.
7- Type (stp enable) to enable the stp
8- Type (int g1/1/3)-enter, type (port link-type trunk)-enter, type (port trunk permit vlan all)-enter, type (description Connect_to_ ??)
9- Configure the step 8 for int g1/1/4
10- Back to global view, type (snmp-agent community read public)-enter, type (snmp-agent community write private)-enter, type (snmp-agent sys-info version all)
11- Create telnet user, type (user-interface vty 0)-enter, type (authentication-mode scheme)-enter, back to global view, type (local-user admin)-enter,
type (password simple ***** -enter, type (service-type telnet level 3)
12- System, ip route-static 0.0.0.0 0.0.0.0 192.168.1.254,enter
13- save the system by type (save) at user view.

-EOF-